View Single Post
  #988  
Old 05-15-2012, 10:53 AM
Ramfd's Avatar
Ramfd Ramfd is offline
Dodge Ram Forum Senior Member!
 
Join Date: Jul 2011
Location: Cordova, Tn
Age: 39
Posts: 571
Gender: Male
Vehicle: 2009 ram 1500 QC 2wd
Trim Level: Big horn
Color: Brilliant black pearl
Rep Power: 4
Rep:150
Ramfd has a spectacular aura aboutRamfd has a spectacular aura about
Default

Quote:
Originally Posted by BlackHemI View Post
was it hard to install the stripes perfectly? ii wanna do mine but knowing me itll be crooked
it really wasnt too bad. each side came on a single sheet of paper. so ididnt have to worry about spacing between the stripes.
i just measured down from the cowl edge of the hood on each side. then all i had to do was determine how far down to run them. they were way longer originally and i cut them to stop at the body line on the fender. I used the wet method to apply.
soapy water in a spray bottle and a squeege. I sprayed the truck and the back of the stripes (on the sticky side, leaving the paper on the top side.) put the stripes where i wanted, they will slide around pretty easy until you start using the squeege. then jsut start working the water/soap solution out along with any air bubbles. I waited a while for it to dry really well then removed the application paper on top then cut the gap from fender and hood. it took about an hr from start to finish i think.
__________________
Belltech 2/4 Drop, Mufflex delete, aFe stage II intake, Pace Edwards Jackrabbit bed cover, Rhino Linings Spray in bed liner, Debadged, Red LED bed lighting, Airlift 1000 kit (part# 60824), Nitto 420s 285/50/20
Reply With Quote