View Single Post
  #4  
Old 05-16-2012, 11:37 PM
rickabev rickabev is offline
Dodge Ram Forum Newcomer
 
Join Date: May 2010
Posts: 16
Gender: Male
Engine: 2009-2010 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:14
rickabev is on a distinguished road
Default

Thanks JB and Crusher.

JB: I didn't use any special tools and I am just a DIY'er. First I popped off the chrome piece that rings the console then there are 4 screws if I remember right. Two under the cubby hole at the front and then two under the drink holders. You can then pop the top portion of the console up and rotate it off. I then figured out where i wanted it and then drilled a pilot hole. You can then use an auger bit or a hole saw type bit to drill out the size of the gauge. My bit wasn't quite big enough so I used a dremel tool with a sander bit on it to fine tune it so the gauge would drop in. You can then use the mount that comes with the set to secure it to the console. It worked well and is secure.
Reply With Quote