View Single Post
  #3  
Old 05-30-2012, 11:29 PM
namretsud's Avatar
namretsud namretsud is offline
Dodge Ram Forum Senior Member!
 
Join Date: Mar 2012
Location: SW Ontario
Age: 59
Posts: 463
Gender: Male
Vehicle: 2007 1500 Mega Cab 4X4 3.73
Trim Level: SLT
Color: Inferno Red
Engine: 2003-2008 345ci (5.7L) Hemi V8 345hp 375lb/ft
Rep Power: 3
Rep:185
namretsud has a spectacular aura aboutnamretsud has a spectacular aura about
Default

Well I got my kegg unbolted last night and when I lifted it off I found that there was a missing bolt head on the drivers rear head. Being close to the distributer the was no room for vise grips or anything else to grip and remove the leftover stud. I didn't want to remove the head and at first I couldn't get a nut on it, so I took my dremel with 90* and cutoff wheel and took the top off the stud and then put 2 nuts on and tightened them against each other and I was able to remove it that way. Right now I have everything back together but want to drain the oil first as I feel some antifreeze got down into the pan. Will do the oilchange in the am weather permitting. Strange thing was doing the intake torque in inch #'s instead of ft#. I had an in# wrench but had never used it so it was alearning lesson. Looking forward to firing her up tomorrow.
Reply With Quote