Thread: remove panel ?
View Single Post
  #2  
Old 06-04-2012, 08:33 PM
RC DuDe's Avatar
RC DuDe RC DuDe is offline
Dodge Ram Forum Senior Member
 
Join Date: Aug 2011
Location: Nor-Cal
Posts: 98
Gender: Male
Vehicle: 2011 Ram 1500
Trim Level: 2WD SLT Crew Cab
Color: Mineral Grey
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:10
RC DuDe is on a distinguished road
Default

Remove the rubber tray above the radio. It will expose 2 T20 torx screws. If your truck has the 110V outlet on the right hand side you'll have to remove the outer trim piece around the outlet exposing another T20 torx screw. Once you remove the screws you'll have to pry the bezel out between the dash. The bezel is held in with a lot of clips. I think a dozen or so. I made a plastic pry tool out of some bicycle tire levers by grinding the end down and making a smooth thin flat end. Just be careful as you pry between the dash and the bezel. I started in the top outer corners. Once you get that bezel off you'll understand the rest.
Reply With Quote