View Single Post
  #5  
Old 06-24-2012, 10:16 AM
dankent's Avatar
dankent dankent is offline
Dodge Ram Forum Senior Member!
 
Join Date: Nov 2010
Location: Kitchener Ontario Canada
Posts: 261
Gender: Male
Vehicle: 2012 Ram 2500 Crew Cab 4x4
Trim Level: Laramie Limited
Color: White
Engine: 2011-20?? 409ci (6.7L) Cummins Turbo Diesel 350hp 800lb/ft
Rep Power: 0
Rep:32
dankent is on a distinguished road
Default

Well after a long day yesturaday, Its all done. put the center bezel back in this morning

Initial test last night I was loosing about 2lbs pressure an hour. So i decided to soapy water test all the connections.

Toggle switch copper lead pulled out when i removed one of the wires .. will need to find one of those, but its sitting in there loosely atm till i can replace it.

Had to re-tape the pump fitting as it was leaking, also had to remove the whole airbag from the drivers side ... lol figures, couldnt have been the passenger side.... But i had to re-tape that fitting as well. Also had alot of issues with the bleeder valve that after a couple re-tapes and a slight tossing accross the garage .. doesnt leak anymore.



So all in all it wasnt so bad, easy enough to do for a DIY'er.
Reply With Quote