View Single Post
Old 07-19-2012, 10:25 PM
Pull Ya's Avatar
Pull Ya Pull Ya is offline
Dodge Ram Forum Senior Member

Join Date: Jul 2010
Location: Cedar Creek, Tx
Posts: 1,280
Gender: Male
Vehicle: 2013 Dodge Ram Laramie 4x4
Trim Level: Laramie
Color: Deep Cherry Red Crystal Pearl
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 5
Pull Ya is just really nicePull Ya is just really nicePull Ya is just really nicePull Ya is just really nice

The clay bar will clean the surface. It will remove all the sap, ground in dirt and other contaminates that you usually can't see. To check to see if the surface is free from any contaminates, put a cheap zip lock bag on your hand and rub the surface with your hand. It should be smooth as a babies butt. Once the surface is completely clean then you can start with the polishing, sealing and waxing process. Sometimes when you use a clay bar it will leave small, sometimes hard to see scratches in the paint. When that happens you have to use a polish to remove the scratches before you put any sealant or wax on. The sealant and/or wax will not completely remove all of the scrathes. If it doesn't leave small scratches then you can go straight to the sealant. When you use the sealant, remember that less is best. It can be applied with either a buffer or by hand. I apply mine by hand. Always use microfiber towels.
Just cause it's loud doesn't mean it's fast and just cause it's shiney doesn't mean it's protected. Remember, going fast costs money, so how fast do you wanna go?
Semper Fi Forever
Reply With Quote