Thread: Y Pipe Kits????
View Single Post
  #3  
Old 08-03-2012, 08:58 AM
snrusnak's Avatar
snrusnak snrusnak is offline
Dodge Ram Forum Senior Member!
 
Join Date: Jan 2011
Location: Orlando
Age: 27
Posts: 13,379
Gender: Male
Vehicle: 2010 Dodge Ram 1500
Trim Level: SLT
Color: White
Engine: 2008-20?? 287ci (4.7L) PowerTech V8 310hp 330lb/ft
Rep Power: 12
Rep:1385
snrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud ofsnrusnak has much to be proud of
Default

There is the pacesetter one(aluminized steel, crosses behind the transmission, and for 3rd gens only I believe), the one sold by exhaust junkie(is SS but not sure if it's for 4th gens, conflicting info, and goes under the transmission), and others I'm sure. I'm not aware of ANY that say they are for 4th gens and direct fit.

That said, the 3rd adn 4th gens are nearly identical as far as fitment for this so I'd think you could get a 3rd gen y pipe and have an exhaust shop weld it in easily.

I was thinking of even doing it on my 4.7L, the exhaust routing appears identical to the hemi. I decided though to just buy all the pipe and bends and just weld it all up myself, save some money. I'm using aluminized steel because I'll probably be changing it eventually and I don't live in a very corrosive environment. SS is expensive, especially for mandrel bends.
__________________
Sean

Breathing in and out is good enough for me.
Reply With Quote