View Single Post
Old 08-06-2012, 07:33 PM
navystg2 navystg2 is offline
Dodge Ram Forum Newcomer
Join Date: Jul 2012
Location: Brunswick, GA
Age: 27
Posts: 23
Gender: Male
Vehicle: 2011 Dodge Ram
Trim Level: ST
Color: Mineral Grey
Rep Power: 0
navystg2 is on a distinguished road

Thanks all for the replies.

I completely removed the front mounting brackets and measured them. They both are the exact same size. I laid the actual bar down to make sure it is even. Everything seemed ok. So I reinstalled the brackets and the bar. The driver side still looked a little crooked.

At this point, I am figuring the actual body mounts on the frame of the truck are maybe a little off. I've exhausted all options. So last week I decided to just stick some washers in between the mounting bracket and the bar itself to see if it raises it. Not 100% but it looks a lot better.

What do you think?
Attached Images
File Type: jpg DSCN1136.jpg (122.6 KB, 42 views)
File Type: jpg DSCN1137.jpg (114.5 KB, 40 views)
File Type: jpg DSCN1138.jpg (122.6 KB, 38 views)
File Type: jpg DSCN1139.jpg (112.8 KB, 36 views)
Reply With Quote