View Single Post
  #2  
Old 09-12-2012, 04:13 PM
JeffreyCH's Avatar
JeffreyCH JeffreyCH is offline
Dodge Ram Forum Junior Member
 
Join Date: Aug 2012
Location: Lincoln Ne
Age: 45
Posts: 37
Gender: Male
Vehicle: 1996 Dodge Ram 1500 4x4
Trim Level: SLT sport
Color: red
Engine: 1994-2001 318ci (5.2L) Magnum V8 220hp
Rep Power: 0
Rep:10
JeffreyCH is on a distinguished road
Default

I just did my upper and lower drivers side, and had to take the hub, wheel bearing and stub shaft out in order to get the ball joint press in there. As for the king nut, I took grinder with a heavy duty cut off wheel to it. To get the hub/bearing/shaft assembly out there is 3 8 point head bolts to remove. It was kind of a b****, since the bearing was rusted into place. I went to U-Pull-It and got different bolts because I had to beat the bearing out by hitting the bolt heads.
Reply With Quote