View Single Post
  #3  
Old 10-01-2012, 04:28 PM
GTyankee's Avatar
GTyankee GTyankee is online now
Dodge Ram Forum Senior Member

 
Join Date: Dec 2009
Location: San Diego East County, Ca
Posts: 19,321
Gender: Male
Vehicle: 2009 Dodge Ram 1500 2X4
Trim Level: quad cab SLT
Color: sunburst orange pearl
Rep Power: 20
Rep:2616
GTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond reputeGTyankee has a reputation beyond repute
Default

P2314 DODGE - Ignition Coil D Primary Ctrl Circ Low
you could try switching that coil with a different one on the engine
if the Code changes to that other place where you put coil, something is wrong with that coil pak. If it remains the same, it may be a EGR , TCM, PCM issue

P2299 possible answers from other Ram owners

P2299-BRAKE PEDAL POSITION / ACCELERATOR PEDAL POSITION INCOMPATIBLE

Set Condition:
The PCM recognizes a brake application following the APPS showing a fixed pedal opening. Temporary or permanent. Internally the PCM will reduce throttle opening below driver demand. One trip fault and the code will be set within 5 seconds. ETC light will illuminate, the light will only stay illuminated while DTC is active.



Possible Causes

DRIVER PRESSING ACCELERATOR PEDAL, THEN PRESSING BRAKE PEDAL, AND CONTINUES TO HOLD THEM DOWN SIMULTANEOUSLY

STOP LAMP SWITCH

APP SENSOR
The most likely cause of this DTC is Brake Torquing the engine by pressing the Accelerator pedal and the pressing the Brake Pedal.


Diagnostic Test
1. DTC INFORMATION
NOTE: If a pedal assembly becomes mechanically stuck the voltage output will stay fixed, if this is also
Followed by a long application of the brakes this code will set.
NOTE: When this code sets the pedal position in the PCM software will ramp to idle. If the Pedal voltage
changes OR the brake pedal is released, the pedal position in the PCM software will ramp up to the pedal
position and the ETC light will go out.
With a scan tool, read DTCs and record the related Freeze Frame data.
Diagnose all other Stop Lamp Switch and APP Sensor codes before continuing.
This code can be set by a driver who uses both feet while driving, one for the Accelerator Pedal and the other for
the Brake Pedal.
NOTE: The most likely cause of this DTC is caused by the customer Brake Torquing the engine by pressing
the Accelerator pedal and the pressing the Brake Pedal.
Ask the driver of the vehicle if these conditions apply to their driving habits.
Are the listed conditions part of the customers driving habits?
Yes >> Advise the customer of what caused the DTC. This is normal operation of a ETC equipped vehicle
because of safety issues.

my comment:
Sounds like something you would do while staging for a drag race
__________________
Ram 1500 SLT Quad cab, 5.7 HEMI(R) MDS VCT, 5 speed auto 545RFE, 3.55 differential gears, 18" Magnaflow muffler, EGR bug deflector, Bushwacker fender flares, customized Nfab nerf bars, CB radio, Autonet wi-fi router, custom soft tonneau cover, Line_X bedliner, DEBO Step, build date 10/15/08 a Wednesday built vehicle
Reply With Quote