Thread: please help
View Single Post
Old 11-12-2012, 09:21 AM
jaynles jaynles is offline
Dodge Ram Forum Newcomer
Join Date: Nov 2012
Location: houston
Posts: 3
Gender: Male
Vehicle: 1998 dodge ram
Color: green
Engine: 1994-2001 318ci (5.2L) Magnum V8 220hp
Rep Power: 0
jaynles is on a distinguished road

i have tried this and it didn't seem to work either. i have also stood trans on tail shaft. it only goes in same. I have installed many chevy torque converters but this is my first dodge. I am starting to question if i have the rite converter, it seems to bottom out before it is in far enough. I tried to bolt trans up and torque converter contacts plate and bell housing has a half inch gap. converter looked the same but i didnt pay attention of the length of engageing cone... is this a possibility? it feels like i may get a little engagement on second clunk. I realy do appreciate any help as i am out of things to try. Thanks in advance
Reply With Quote