DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - OEM splash guards
View Single Post
Old 11-23-2012, 04:28 PM
sweenmystr's Avatar
sweenmystr sweenmystr is offline
Dodge Ram Forum Member
Join Date: Nov 2012
Location: Mississauga,On
Posts: 51
Gender: Male
Vehicle: 2013 Ram 1500 Sport
Trim Level: Sport
Color: Mineral Grey
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
sweenmystr is on a distinguished road
Default OEM splash guards

I got around to installing the rear mud flaps today.

I removed the items listed on the instruction sheet. One word of advise, don't get your truck undercoated before you do this. It gets pretty messy, atleast it was for me.

Purchased some 3m paint protective film(after reading some threads) and installed them in 3" strips, 12" long. I just trimmed the top to make it square to the body of the truck. Fairly easy. When I do the fronts I might make a template first then cut the material to fit the contour of the area.

Install was straight forward, another hand would have been a little easier lining up the bottom screw but other than that I would say pretty simple.

I didn't drill the recommended hole as I think the three screws are holding the guard firmly.

Monday, the fronts!!
Reply With Quote