View Single Post
  #1  
Old 11-29-2012, 09:16 AM
xsdbs xsdbs is offline
Dodge Ram Forum Senior Member!
 
Join Date: May 2011
Location: Over Here, Hi
Age: 54
Posts: 801
Gender: Male
Vehicle: green flying carpet
Trim Level: upper and lower
Rep Power: 0
Rep:73
xsdbs will become famous soon enough
Default 2011 Uconnect SW update info

Hello forum members,

In response to a PM that I received today from a member:

I know that I have this information in several threads, but I can't remember which ones. So I'm going to start a thread with the 2011 Uconnect SW update.
This is the update that has been out since June of 2011. It's for 2011 vehicles that were built prior to 6-1-2011 and have one of the radios (RES, REQ, RBZ & RHB) ONLY. It is not for the Harman radios (RER, RHR).
This update will fix the "error occurred" that is displayed when connecting an iPod or IPhone to the docking cable. It will also fix the choppy audio when streaming audio thru BT.

Here are the instructions:
Make sure that you DO NOT have any power interruptions during the update, for best results have the motor running so there are no interruptions).
You will need at least a 2 GB thumb drive. If you have files on the thumb drive, please delete them and format the drive (to FAT32) just to make sure that it is completely clean.
Download it to the thumb drive that has no other files on it. Turn the radio on, Place the thumb drive in the center console USB connector (on vehicles with the dealer installed unit, it should be in the glove box), press and hold the Uconnect button for about 12 - 15 seconds, you should here "update started". This process should take about 15 - 20 minutes; there will be some beeps during the process. Please listen during the update for any error message that may be said by Uconnect. When the update is completed, the radio screen will go back to a radio display. Turn the ignition off, open & close the driverís door. Wait about 1 minute, then turn the key on and test the system.

And here is the file location:
uconnect.upd


Part 2
Iím also going to add this update here for members that have just applied the above update. You will notice that the Bluetooth streaming audio sound quality is not so great. After you have applied the above update then (and only then) apply this update the same way that you did the one above. Go to my thread link below and see post # 23 for the file link.
http://ramforumz.com/showthread.php?t=116127&highlight=2011+streaming+a udio&page=3
Reply With Quote
Sponsored links