View Single Post
  #3  
Old 01-01-2013, 01:11 PM
Kman521 Kman521 is offline
Dodge Ram Forum Senior Member!
 
Join Date: Dec 2012
Location: Ontario, Canada
Posts: 133
Gender: Male
Vehicle: 2013 Dodge Ram
Trim Level: SLT
Color: Black
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:11
Kman521 is on a distinguished road
Default

Quote:
Originally Posted by rraulston View Post
my 2013 is the same as yours. Have the 4 and 7 pin connectors in the bumper and no factory controller. Cant find the connectors everyone talks about. Under the dash by the center console, there are a few loose connectors. I bet they are for the factory controller which mounts in that location. Dealer says the components required for a retrofit will not be available till march. I tow in 2 weeks. Here is what I will be getting:

http://www.etrailer.com/Brake-Contro...FYl7Qgodg3EALg

I am banking on this being cheaper than the factory panel and module. Ray
If I can find the factory plugs I'll be using a Draw Tite 20273 wiring cable to wire my older Tekonsha. That cable is listed for 2011 to 2013 and sell for $20 locally to me.
I can't imaging the factory not installing the factory wiring when it has both connectors at the rear bumper, they must be somewhere.
It's cold and snow is on the ground right now so it's PITA looking but I don't really need to have trailer brakes until the spring so I have lots of time.

Keith
Reply With Quote