View Single Post
  #21  
Old 01-01-2013, 03:52 PM
Ripper's Avatar
Ripper Ripper is offline
Dodge Ram Forum Senior Member!
 
Join Date: Dec 2012
Location: DFW
Posts: 80
Gender: Male
Vehicle: 2012 Ram CCab
Trim Level: ST
Color: Mineral Gray
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:33
Ripper is on a distinguished road
Default

Quote:
Originally Posted by UNBROKEN View Post
I keep thinking about dropping mine another inch but not with the rear link bars mounted like they are now. I have some ideas on those....the upper bar would be easy. Trim a couple of spots on it's mount and drill a new bolt hole and you could drop it a couple of inches. The lower bar will take some fab work and welding but doesn't look too hard to drop. Once those are moved a standard old school c-notch could be put in for some more travel. Notching the frame as it sits and the upper link bar will be the first point of contact with the frame....it already is if you have bump stops that are too short installed. I learned that the hard way.
With your drop , which bumpstops do you recommend for the rear to
keep the upper bar from making contact ?
Reply With Quote