View Single Post
  #3  
Old 01-12-2013, 10:36 PM
Oldy but goodie Oldy but goodie is offline
Dodge Ram Forum Senior Member
 
Join Date: Aug 2012
Location: maine
Posts: 76
Gender: Male
Vehicle: 1972 dodge 200
Trim Level: base
Color: blue/silver
Engine: 1992-1993 318ci (5.2L) Magnum V8 230 hp 280lb/ft
Rep Power: 0
Rep:10
Oldy but goodie is on a distinguished road
Smile

Quote:
Originally Posted by cas390 View Post
gonna replace everything up front as far as ball joints tie rods coil springs etc. what avenue should I go as far as good replacement parts. which brand? moog,dorman etc. also should I use rock auto or local parts warehouse.

Was thinking of putting on d250 coil spring or heavier duty than original. was trying to get the front end up a little higher. I don't know if going with taller coil would affect the other components. any of you guys every do this? input? please?

thanks, Chris
I installing D250 coils I think would make a very stiff ride on A D150.
Even if you upgraded every thing to D250 all it would is make the ride stiffer upset handling. Moving your suspension to heavy duty 1/2 componets both front and rear would be eaiser and less expensive. It would stiffen up suspension but not as stiff as a 250. There are many kits to raise all types of vehicles and are safe. I would not recommend using cut coils on the front. I have on a number of times used airbags they work great and are adjustable by adding or removing air. Give a stable ride.

Last edited by Oldy but goodie; 01-12-2013 at 10:40 PM. Reason: clarify a point
Reply With Quote