View Single Post
  #175  
Old 01-29-2013, 11:41 PM
Encr1pt10n Encr1pt10n is offline
Dodge Ram Forum Newcomer
 
Join Date: Nov 2012
Location: Washington D.C
Posts: 7
Gender: Male
Vehicle: 2012 Ram
Trim Level: Express
Color: White
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:10
Encr1pt10n is on a distinguished road
Default

this is a great mod for any ram owner to do to their truck, and a great detailed write up too. I performed this mod over the past weekend and noticed that it was a tight fit due to the location of the cutout. I dropped the blower fan out to make it easier. Now if I may add a bit of advice that I did myself, I would recommend anyone with access to a drill and a drill bit to use one. What I did was I used the drill to drill pilot holes about every half inch along the inside outline to make cutting with a box knife easier and cleaner especially in the corners. Anyone who has a dremel I suggest using it to make your life easier. With that quick added tip I will say from start to finish this mod only took about 25 mins, and I do encourage everyone who is going to do this to BE PATIENT and not get frustrated. Good luck to all!
Reply With Quote