DODGE RAM FORUM banner

Need to remove the driver side door Panel??

10K views 6 replies 5 participants last post by  jjjmcconnell 
#1 ·
I've got to replace my driver side mirror ( seems the door garage door shrunk:Wow1:).
Anyways purchased the part through Discount Auto Mirrors , and appears OEM.
I need to take off the door panel to get at the wiring harness.
Does anyone have the how to get the panel off ??
I see a few screws , but not sure about the door handle etc .
 
#2 ·
REMOVAL





NOTE: Rear door switch shown, front doors are similar.
1.Using trim stick C-4755 or equivalent, release the door switch/bezel (1) from the door trim and disconnect the electrical connectors (2), if equipped.




2.If equipped, remove the manual window crank (1) using a window crank removal tool (2).



3.Using trim stick C-4755 or equivalent, remove the mirror flag (4).
4.Remove the screw (2) and remove the interior handle bezel (3).
5.Release the plastic push pins (1).
6.Raise the trim panel (6) upward far enough to disengage the hooks on the back of the panel from the inner door and the door lock knob from the top of the panel.
 
#6 ·
Door panel removal 02 dodge ram

I am having the same issues on my 02 ram im nit very good with the sizing of bolts but i was curious if the t30 torx driver is there other sizes for the t30 ? I need it or maybe i dont lol just wanted to make sure i have correct size on removing door panel
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top