DODGE RAM FORUM banner

CAI Mod Issue

794 views 3 replies 3 participants last post by  Flygt 
#1 ·
Installed my first Mod to my engine. A Airram MBX CAI. Came apart really easily, went back together just as easy. Except for one problem. I tried for an hour, to take the factory air sensor off. Couldn't, so here is my new CAI with a factory air tube :(
Any Ideas how to take it off?


 
See less See more
1
#2 · (Edited)
it should just pull right out, if i remember correctly when i did mine i had to kinda of pry the grommet out with the plug still in it then take the plug out :) or reuse the same grommet this is what i did :) hope this helps. then you will have something that resembles this :)

 
#3 ·
Use just a touch of dielectric grease. Put a bit on, then give a few twists and it should pop right out. I had the same problem until the grease!! You can do it!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top