DODGE RAM FORUM banner

Been awhile...

492 views 3 replies 2 participants last post by  elinmon1976 
#1 ·
Hey guys! I finally slowed down enough to get on and post. I was strongly considering sending my 98 ram to our shredder yard at one point this past week, but reconsidered after remembering that new trucks are insanely overpriced for average folks. LOL!!!

So, I am down to making a list of this to fix:

After I replace the plenum gasket and pan, I need to address the rear axle bearing.

I have a posi rear end that the PO swapped so this isn't what the truck was born with, how to I tell what I have or will it even matter on the bearing? I understand that this job will be bigger than I am really comfortable doing on my own but Peedoodlum IS a nurse so I can count on excellent medical attention should any be neccessary.:LOL:
 
#2 ·
Hughes Plenum kit cam in today so tomorrow the fun will begin. If this doesn't work, I may set the truck on fire...or curl up in a ball and rock back and forth for a few hours...LOL!!!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top