DODGE RAM FORUM banner

Replacing blackout on door pillar

2K views 1 reply 2 participants last post by  Wildcat 
#1 ·
Picked up my first Dodge last night and ran it through the wash. The high pressure blew off a bit of the blackout on my driver door.

I can't find anything out there that is a specific replacement. Would appreciate some leads on material to use.

What would I even ask for at a parts store ?

Thanks for the help !
 
#2 ·
You could just remove it all. I did that on my truck, and I really like it. It is all painted underneath on the new trucks, so I would guess that it is on yours too. Just use a hair dryer and some patience. Takes about 15 minutes. If you are set on replacing it, check online, I think it is just a vinyl sticker.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top