did you break off the top piece or the part that goes down into the console
If it was just the top piece, look where it becomes the stem that goes down into console
You will see a collar, (a ring), if i recall, you just push down on that collar & you will see how it comes apart.
If you need to get inside of the console itself
First set the Emergency Brake
Then lift out the rubber pad where the floor console & center console meet, you will see 2 screws, don't remove them yet
, they will have to come out, but wait a bit
Now look at the console, somewhere just to the right of where you see the shifter pattern, maybe just where the shifter would be in the Drive position, you will notice a little Tab, it will lift up, that is a RELEASE that when you push down on it, you will be able to move the shifter to any position, WITH OUT using the key in the ignition, you may not need to do that either, just wanted you to be aware of its function.
What you do need to do next is, either using your fingernails, a plastic paint scraper, or a plastic trim tool & very carefully start working the large rectangular chrome trim piece around the shifter up, it is the piece that tries to blind you if the sun is at the right angle.
Before you try to lift the complete unit out of the way, check for more screws, like under the back pad, nearest the storage bins
I have not removed any of that on mine as yet, but i may do it just to see what is in there. Besides that, i had a CB radio tech put a cb into the center console & i may need to work on it some day
you can see the little TAB in this photo