Originally Posted by N8man
my mistake, it is a procomp 2.5" 61170 spacer style. the compressor was needed because jacking up wasn't compressing it enough to reach. it seams as though when the uca swings down it pushes the ball joint out of its angle. it will never be in that position unless off the ground, but just doesn't seem right. do i replace the ball joint, uca and ball joint or maybe an alignment will correct this? i will try to figure out how to add pictures.
An alignment will correct some of it but if its that far off, then there is something else going on. Also, jacking the LCA to the point just before the truck gets picked up off the jack stand is pretty darn close to where it would be when the truck is on the ground sitting on the tires. If that is not enough, then there is something wrong.
First off, what year is your truck? Do you have any pictures of the suspension?