Originally Posted by moose3
I haven't done this on my Ram yet,don't get it until Saturday, but I have done this on every vehicle I have had for the last 5 years. What I do is take a piece of solid core wire, normally small guage (20), and solder it on to the tails of the hacked up detector cord. Then strip about a half inch of the wire, and smash it with the hammer on vise, creates a nice little spade, that you can wedge right in beside the pin connectors, has worked great, and no after effects when you are done with it.
Thanks, I have done it as well but I already have an invisicord from my last vehicle with the flat connectors already attached onto the end of the hacked cord. Just didn't know what slots to wedge them into.