Since no one makes an intake tube only for 2009 and newer I made my own:
airaid u-build-it kit 100-350 3 1/2"
It is a big loop of plastic pipe with various angles, I used a 45 degree
at the airbox and a 90 degree at the throttle body. Cuts real clean with
power mitre saw.
Silicine hose couplers from HPS
I used coupler HTSC-350 at the throttle body and in the center junction.
At the airbox I used flex/hump coupler HTSHC-350.
6 stainless T-clamps needed
The rubber grommet for the air temp sensor: OMAR-2761
I used a #4 unibit to drill the hole. Run the bit all the way through to make
a clean 7/8" hole. Regular drill bits will not make a good hole
Total cost around $200
Very happy with results, running k&N drop-in and fastman throttle body