Well, it took a bit of doing, but I found the solution to complete my 2014 Outdoorsman for full toy hauling duty.
I wanted to be able to haul bikes, luggage and windsurfers on my holidays yet retain the usefulness of the ramboxes and covered cargo area.
The solution is made by VanTech USA, and requires a bit of work, but nothing you couldn'd do on your own.
I wanted it all: Tonneau cover, rack, Ramboxes and bike hauling in the same go.
Everyone will tell you there isn't a stock solution available, and they're right, but a reasonabe compromise can be made modifying VanTech's conversion van racks
. This link shows you how the standard rack works: http://vantech.us/Custom-H1-1-Bar-Sy...2-H-Custom.htm
What I did to make it work on my truck:
1. Take out the Rambox side rails.
2. Take Vantech mounting plates and use one OEM hole and mark second hole, drill and install "Nutserts" or similar product. (you'll also need to buy the installation tool, or find someone with one, they're much like a rivet gun, but leave you with a threaded hole in the body of the truck)
3. get countersunk Allen "(Hex) keyed machine screws to match Nutserts you bought
4. Countersink one hole in plate (I bought Part
No. H14B), and install with some double sided sticky tape behind it to keep it in position over the factory side rails's mounting holes. The plates are flat with a 45 degree bend. I chose to have the bend extend outboard, which restricts your Rambox lid to that same angle.
5. insert Vantech supplied carriage bolts befor tightening plates.
Plates are 1/8" thick steel or aluminum, so you'll need a gasket material in between your plate mounting points if you wish to keep your tonneau covered bed dry. If you don't have a Tonneau cover, I'd suggest you flip the plates inboard as they won't extend past your tiedown rail and will still allow full opening Ramboxes.
6. Build Vantech 53" wide rack (Cut crossbars to length)
7. Drill crossbars to match mounts using supplied templates
8. install at height you'd like to have ensureing cab clearance (Note that your Ram truck roof is lower on the side than it is in the middle, so don't drill or cut uprights too short.
9. Cut the bottom lip off the supplied uprights for additional clearance for the tonneau. You don't need them for strength because he mounting plates are very righid due to them being sandwiched between the rails and the bed. The rack doesn't move while on the highway.
10. I bought SS wingnuts paired with lock washers for easy install/removal. I cut about 1/2" off the SS carriage bolts to limit interference with the factory tri-fold cover. If you go with Vantech supplied locknuts you can cut the bolt even shorter and have limited to no interference with the tonneau.
11. Tonneau cover clamps will need adjustment to inboard direction. The nuts are an odd size, neither 1/2" nor 13 mm. It's easiest to get a No. 5 Allen key and turn from the blind side while holding the nut.
You can have it all, sort of.
altogether cheaper than most complete ladder
rack solutions on the market.
limited opening Rambox if mounted pointing outboard.
Tonneau cover removal is a bit more delicate operation as front end needs to slide under the bolts.
finnicky work which takes up time (ultimately very rewarding though)
I talked to Richard at Call 718 497 3482, and he was patient and helpful. They use US Mail which was cheap and fast. I went with the black anodized aluminum: Very well finished product, and the extrusions give you all kinds of attachment options. All the hardware is good quality, mostly stainless steel. They also make other colors.
I'll figure out how to download pix next.