DODGE RAM FORUM banner

Rear Bummper

945 views 3 replies 3 participants last post by  bigjeff64 
#1 ·
:att:
i need help i bought a bummper to replace my old one but i have a 1997 ram 1500 and the one i bought is from a 2000 1500 the size of the bummpers are the same just looks like diffrent mounting hardware and the licens plate mount on the 2000 is built in to the bummper
 
#2 ·
Well hello and welcome to RamForumZ! Be sure to introduce yourself in the Newbie Checkin, so we can all welcome you proper! :) I don't have an answer to your question, but someone will be along who does, but hope you enjoy the board! :Hey:
 
#4 ·
Once u take the existing bumper off check the spots on the frame where the bumper bolts to and see if there is damage. if not and the new bumper lines up then no need to weld it on. if there is damage then i would evaluate whether or not u can do it or u may need to take it to a frame shop
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top