DODGE RAM FORUM banner

Headlight housing fitment?

901 views 1 reply 2 participants last post by  jasonw 
#1 ·
Hello,
I purchased a used 2015 power wagon a couple weeks ago. The driver's side headlight housing has about a 1/4 gap between the fender and the headlight. The passenger side headlight fits flush. I took the bolts out of the headlight and the plastic clip in the fender well and tried to adjust it, but no luck. Any ideas on what it could be catching on, or should the gap be there and the passenger isn't fitting correctly? Any help is appreciated.

Thanks,
Travis
 
#2 ·
On my 2014, the headlights both fit the same, pretty much flush. If a quarter inch bugs you enough, take it into the dealer, see what they say. Its entirely possible the plastic headlamp is not up to spec. Hopefully its that simple and its not the sheet metal thats off.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top