DODGE RAM FORUM banner

Torque

589 views 2 replies 2 participants last post by  digr 
#1 ·
Hi all, What is the procedure for torquing the rockers on a 95 318

Thanks
 
#3 · (Edited)
valve spring compressor

I got it, 30#torque I had to change valve seals without removing the heads. Found this site and modeled a tool after it. No action pics but it worked great. Built a adapter out of a spark plug and a piece of hex stock. Used air pressure to hold the valves in place when I changed the seals. I only dropped one keeper and I thought it hit the floor but 15 minutes later I found in sitting on the A frame
Next time I am going to buy a few extra keepers. The hardest part was getting the right angle on the stud.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top