DODGE RAM FORUM banner

Throw-out bearing squealing the little F@#$er

2K views 4 replies 3 participants last post by  RamTech 
#1 ·
I need to change my clutch,pressure plate,and throw-out bearing and not sure if I want to tackle the job or take it to a garage to have it done. Any insight on this or pointers anyone could give to make the job smoother? can the trans. slide back on the cross member to change it or does it have to come clear out?:i_rolleyes:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top