here are some of todays install pics, I pulled a few to give you an idea of what you are looking at.
Start off by removing the 2 screws from the front, and the lock from inside the wheel well.
Remove the cap from the headlight housing and remove the oem bulb
I used a dremel to grind down some of the tabs, about a 1inch in diameter, and then drill a hole in the center and dremel out a 1inch hole and pull through the rubber seal
Twist in the bulb and connect the ballast to the oem plug and that's it
The fogs are simple, just unplug the connector, twist out the oem bulb, twist in the new bulb and plugging the ballast to the bulb and oem connector, very simple really.