DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum

Go Back   DODGE RAM FORUM - Ram Forums and Owners Club! - Dodge Truck Forum > Dodge Ram Forum - Help Zone - Dodge Ram Problems, Complaints, & Solutions - Maintenance & Re > Dodge Ram Knowledge Base


Notices

Dodge Ram Knowledge Base Here you can find owner submitted how-to's for performing various mods to your Dodge Ram!


Latest Vendor News
AutoAnything
Addictive Desert Designs!
United Radio
Bayou Goat Mounts

Reply
 
Thread Tools
  #1  
Old 11-04-2013, 11:50 AM
hriczko806's Avatar
hriczko806 hriczko806 is offline
Dodge Ram Forum Senior Member!
 
Join Date: May 2012
Location: Lehigh Valley, PA.
Posts: 194
Gender: Male
Vehicle: 2004 Ram Quad Cab
Trim Level: SLT
Color: Black
Engine: 2003-2008 345ci (5.7L) Hemi V8 345hp 375lb/ft
Rep Power: 3
Rep:91
hriczko806 will become famous soon enough
Default How-To: retrofit minivan door lock actuator on 3rd gen **Save big $$$**

I recently had the all too familiar issue with my driver side front door where I could open it from the inside but not the outside. After some research I found that the door lock actuator went bad. The cheapest replacement part I could find was $75.00 online and no wreckers around my area had 3rd gen rams available. However, they had an abundance of Chrysler/Dodge minvans. This is how I fixed it for $6.00.

After searching the wrecking yard for an hour without finding one 3rd gen Ram I decided to start looking at Durangos and Minivans. Surprisingly I found a lock actuator from a 2003 Chrysler Town & Country that looked almost identical. With a few minor mods with a dremmel tool I was able to swap the actuator and only paid $6.00 for it.

Step 1
Remove door panel from door.

Step 2
Remove lock actuator from Ram. To do this you unbolt the three fasteners holding on the door latch. Pull back plastic barrier on door and unhook all 4 rods going into the actuator. (Unfortunately I didnt take pics while doing this but you will get the idea from the pics below) Then just pull the actuator out from the door.

Step3
Take both actuators to a work bench and take some time to look over both. You'll see the only difference is there is an arm with a weight on the T&C actuator, where as the ram has no weight, a shorter arm and a spring. (You have to cut the weight off from the T&C actuator and transfer the spring to and its ready to go)

Here are some pics to compare the two:

Ram:


ram lock 2 by zxsix, on Flickr


ram lock 1 by zxsix, on Flickr

Town and Country:


minivan lock 1 by zxsix, on Flickr

As you can see the electrical connectors and the rest of the actuator are identical.

I took a metal cutting wheel on the dremmel and cut the arm on the T&C to match the Ram actuator and then just transferred over the spring.

Also I should note that when you get to the spring its easiest to just cut off the whole arm on the Ram actuator to get the spring off (Its already broken so why not)

On the new actuator theres a collar that holds the spring in place. Youll have to grind two of the edges down to slide the spring over, just dont grind the whole thing because it still needs to hold the spring.

Step 4

Reinstall the new actuator. Install is reverse of removal.

Good Luck!!
Reply With Quote
Sponsored links
  #2  
Old 11-04-2013, 12:00 PM
Iqudayo's Avatar
Iqudayo Iqudayo is offline
Dodge Ram Forum Member


 
Join Date: Dec 2012
Location: Hopatcong, NJ
Age: 48
Posts: 874
Gender: Male
Vehicle: 2010 Dodge Ram 2500HD
Trim Level: Big Horn
Color: Mineral Gray Metallic
Engine: 2007-2011 409ci (6.7L) Cummins Turbo Diesel 350hp 650lb/ft
Rep Power: 3
Rep:563
Iqudayo is a name known to allIqudayo is a name known to allIqudayo is a name known to allIqudayo is a name known to allIqudayo is a name known to allIqudayo is a name known to all
Default

Nice find I'm sure it will help someone
__________________

To many mods to list ask and I shall give you all the information, and help I can.
Everything from outside to interior.
Reply With Quote
Reply

Bookmarks

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Advertisement






All times are GMT -4. The time now is 10:49 PM.


= Copyright RamForumZ.com a Gigathreads.com Network Site =Ad Management by RedTyger
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
vB.Sponsors


=Gigathreads Network=
CLUBS MOPAR NATION DSM GPMM MAMM JAM
DIESEL Diesel Forum      
CHEVY Chevy Camaro Forum Chevy Volt Forum    
CHRYSLER Chrysler 300C Forum      
DODGE Dodge Avenger Forum Dodge Caliber Forum Dodge Challenger Forum Dodge Charger Forum
  Dodge Circuit Forum Dodge Hornet Forum Dodge Magnum Forum Dodge Nitro Forum
  Dodge Ram Forum Dodge Dakota Forum Dodge Durango Forum Dodge Dart Forum
FORD Ford Raptor Forum Ford F150 Forum Ford F100 Forum  
JEEP Jeep Forum      
PONTIAC Pontiac G8 Forum      
SRT SRT Viper Forum SRT Cuda Forum