Originally Posted by snrusnak
Hey do you have more info/pics on how you did the intake scoop? What size is the "collector"? And I assume you cut out the vertical slats in the plastic bumper right? Thanks!
I will add all the pics i have and explain what i can. Idid cut away the small up right slats that was just behind the filler panel, then I also had to notch the larger bracing also.
This is the filer panel before cutting.
filler panel after center cut away. I needed the ring for the mounting clips so it would mount back up later
here the slats are removed only leaving the larger braces that i did later have to notch. you can see one of the slats on the ground.
here i started laying out the shape card board. the collector tube is a piece of 3" tube. the back side of the assembly is also pieces of 3" tube that i cut in half long ways and used them as the curved backing.
the plastic tubes was from a air intake mock up kit i bought form autozone a few years ago. it had different elbow angles and straight oieces.
here i started laying the fiber glass, then i removed the cardboard
you can see the box of air intake pieces in the box on the floor.
this piece is the adapter i used on the airbox. i just cut out a hole and fitted it form the in side of the box, and i reinforced it with a piece of diamond plate on the outside.
test fitting it here. You can also see the notches i made on the main braces.
you can see the diamond plate here and the 4" flex duct. I did go back and plasti dip the ducting so it didnt stand out so bad.
you can see the ducting after it was plasti dipped, it blends in a bit better now.
hope that helps. I tried to take as many pictures as i could.