This is a work in progress, but it is not for the faint of heart.
Modded bodies for clearance, going to mill out the top to make room for a common mounting flange surface, re-route the fuel rail cross over, shorten the runners for clearance... and a few more things I am sure I will run into.
Front body gets the MAP, middle gets the TPS and rear gets the IAC.
Linkage layout remains the same, front get the front half of the bracket, rear body gets the rear half, and then a common bar to link the shafts.
Result.... Magnum Six Pack!
Should sound a little awesome at full throttle, which is what started me down this road in the first place. I am going to put on some quiet pipes so I can hear the throttle scream!
Last edited by ElSombreroNegro; 02-05-2013 at 07:36 PM.
Will do! Also open to ideas and suggestions for fabing and mounting the air cleaner. I don't think I can make my k&n work for it after this....
I could also use another throttle body if someone has one laying around.....
Thanks Buddy! you will have to show me what I was doing wrong posting this video!
you have to enter [youtube] video number goes here (the very last part of the url in your case it was "nDH9NifrS4Y") "/youtube" replace the quotation marks with [ and ] and it will embed the video to the board