So I got a request for some pictures for how I installed my USB cable for power for my phone when mounted on the Goat Mount.
So, first off you need one of these:
Then you can unscrew the torx screws in the tray:
Once you have the screws undone, gently pry the tray out:
Then if you look at the cubby you'll see:
Feed your cable down the drivers side hole... Then down by your right foot, you'll see a kick plate that you can remove:
And if you look up, you should be able to see light from the two holes in the cubby.
Jiggle the usb cable up and down and around until you can see it somewhere around the area of the kick plate. Grab it and pull it through. Then feed it along the floor and tuck it up under the plastic of the floor console:
And bring it up into your arm rest or to the rear power outlet (if you've moved your fuse to position 91 for always on power):
(I bought a 90 degree USB adapter to help prevent accidental banging of the usb cable by the kids/dog. So far so good.)
Then, depending on the size of the cable you are running, you may have to increase the size of the hole in the tray. I had to use a 5/8 spade bit because I have a coil on the cable:
Once you can feed the cable through, snap the tray back into the console - carefully (put the rear of the tray into the slot first, then I gently pushed on the centre clip and then the two side clips with a flat head) and you'll end up with this:
Make the modification to the rubber tray so you can fit your mount and the usb cable through and place the mount and screw it back in:
And you end up with (which will hopefully win me the dual mount!