Next comes the center dash piece:
Screw one behind cover on power inverter
Two and Three are under the little cover on the top of the dash.
Remove all screws, get ahold of the dash by the top and give it a nice tug... and presto. bezel removed.
Remove all these plugs and just set it to the side.
Remove the 4 screws and the new/old radio slides right out.
ISSUE NUMBER 1!!!!! You have to take a dremel to the dash to make any double din fit... its a pain but it has to be done. Just trim and fit until you are satisfied.
Make all the connections with the wires and plug in your wire harness.
This little thing makes it so you can play videos wile moving.
And to make your factory sirius work with any pioneer unit you need this and the Sirius sc-c1 to adapt it. both cost about $70 $140 total. Ebay and other sites have them cheaper but I decided to just buy them from the store.
Conveniently comes with 2 velcro strips to install... Installed right below the radio.
When it comes to installing ipod adapters or anything else dont even think for a second you can run it through an empty button/switch slot... they are circuit boards and cannot be messed with unless you know what your doing.
Put everything back together and your in business.
Hope this helps anyone out!!! let me know if you have any questions or requests.