Search Results for ‘2nd gen’

So my idea is to put a turbocharger on my Dodge V10 Magnum. The turbo only really needs to be effective below 3000 rpm, 2500 down to 1200 or something like that would be fine. 7 psi or less. Just thinking what turbo would work for this, what size is optimal, etc. The truck runs strong, but the...

Hello to all. Soo i got a 98 1500 4x4 5.9 magnum. Have issues with my wipers, works low and hi. On delayed settings wipers pause halfway up the windshield before returning. fuses and relays are good, checked grounds, replaced wiper switch, integrated timing module by the column behind the...

I have a 2001 Dodge Ram ext cab 1500, bought it with a 5.2 motor and trans. They are both almost at 200,000 miles, and the transmission has been well taken care of so I decided to swap the motor to the 5.9. A mechanic friend's friend said he had a 5.9 with 150k miles that they took out of...

I have a 97 ram with the 5.9 magnum. I have o2 bank one sensor one high voltage code. All new o2s. I have no power under 3k rpm. What may cause this. I'm thinking a clogged cat or a wiring problem. Any ideas as to what else it could be?

I have tried to dig around for weeks now trying to find an exact answer, but I cannot find a definite answer. I have a 1998 Ram 1500 2WD and as many of you probably know on here, that the hub on these trucks stick out rather far, I am trying to find new wheels (currently running American Racing...

So i was checking my oil (on my 1998 2500 V10 five-speed 8.0 motor) and when I went to put my dipstick back in the tube and went down with it. So i crawl up under my truck to check it out, I realized that my dipstick tube has snapped off level with the block. So I called Dodge for them to tell...

ok so i have a bit of a problem right now. I'm finishing up my manual swap on my 96 5.2 ram with the nv3500. I've got it almost completely done now, but at the moment I'm getting a crank but no start with no spark to the coil or the distributor cap. Now for starters I went through every forum I...

So I bought this 99 ram that wouldnt start, the windows didnt work and the blower motor for the a/c didnt work. I played with the ignition and got it to crank up so i knew it was a bad ignition switch along with those other symptoms. I replaced it with a cheap one I got online and it fixed all...

Hey guys, just installed a 3rd gen center console and wondering what some of you had done with the lower storage as it doesnt contact the floor, bout a inch and a half short. Console was relatively easy, didnt take pictures, but, if you pull the console cut 3/4” off the end of each bracket, then...

In 1999 my dad bought a brand new Dodge Ram 1500 in Deep Amethyst purple, the first brand new vehicle anyone in my family had ever owned. In 2001 my dad had to sell his dream truck to support is family. I would really love to be able to by the truck back for him but I need helping locating it. I...

I am wanting to install a new set of doors, from a 2000, on my truck, which is a 2001. My drivers door is messed up and I found a guy that has both doors and they have power accessories. As I would like to have the power accessories, I will just get both doors. However, I do not understand...

Hi guys, I've never owned a dodge ram before, wondering what it is I should look for to see whether or not I pull the trigger on a 1999 Ram 1500, Club Cab, Auto W/ 113k. Any red lights to just leave the truck be. Currently being sold for $2000, will try $1800. Brother told me the truck seemed...

Hey guys i found out that my tailgate post on the drivers side has rusted to the point its almost non existent anymore, what do you use to replace these cause i know the 3rd and 4th gens there bolted in but these are made into the post ill post a picture sometime towhere yall can see how bad it is.

hey guys looking for help not trying to spam or cause me to get kicked off but i figure more people would see my thread here so here it is i have a 2001 ram 1500 QCSB 4x4 automatic with the 318(5.2L) and got a 5in rough country lift kit to install for half price almost new barely used(1 week or...

Looking for some help! Swapped out my blown 1997 5.2 engine with a used (tested) engine from a local supplier. The engine came from a 1995 5.2 Dodge Ram. Once everything was installed the engine idles very rough and throws a code for crankshaft position sensor. The sensor was swapped out twice...

I bought my 1997 ram a few months ago without a key fob. I bought a new fob but I didn't come with instructions on how to program it. I have been looking everywhere online for instructions but none of them seem to work. The data link connector DOES NOT have a dark green wire in one of the corner...