airbags

Received this email yesterday from the NHTSA: Your vehicle MAY be involved in a safety recall and MAY create a safety risk for you or your passengers. If left unrepaired, a potential safety defect could lead to injury or even death. Safety defects must be repaired by a dealer at no cost to...

Hi I have a 1500 and a 3500 6.7 Dually, the 3500 is a mega cab and I tow a 30 ft ultra lite 5th wheel it, great for towing but the ride as a daily drive is not good, the 1500 is like a limo in comparison. My question please if I can get a 2500 mega cab is the ride better than the 3500 and would...

Hi Guys, I just installed an Air Lift WirelessOne on board compressor in my truck to run my Air Lift 1000 bags. I mounted the compressor, manifold, and relay above the spare tire bracket in the back (figured that was the best place to keep it as dry as possible without putting it inside the...

Got into a car accident back in February. Got hit by a Ford F250 Diesel. Biiiig truck. Anywho, it was totaled. I walked away with nothing but a sore shoulder. Our trucks perform beautifully in accidents. I can now say that I know from experience... On the plus side, I got a new Ram 1500 that was...

After reviewing my service manuals and evaluating my 2003 Dodge Ram Quad Cab wiring harness, I decided that, if I bought a Passenger Airbag On/Off Switch that it would plug into the wiring harness and be capable of disabling the Passenger Airbag (as in the 2003 Standard Cabs). I disconnected...

1998 Dodge Ram 1500 Empty truck, no load, ride too firm, every bump (chicagoland) kills. Can I put in Air Bag helper spring, and remove some leaves from leaf spring to bring back to level ride (stock) then by just filling bags to level and get a softer response to bumps. Then when I load up...

I currently have one Air Zenith air compressor with two 3-gallon tanks running my airbag system but I want to upgrade to an engine driven compressor on my 2005 5.7 Hemi. Does anybody have any info on where to get a compressor bracket or have any ideas or suggestions on engine driven compressors...