1. 2016 u joint replacement

    Looking for what is the best replacement u joint for front axle left and right outside joints. 6.4 gas model, not sure if that makes it any different. I’m sure there is a feed out there but I can’t seem to find it! Thanks in advance for your suggestions!!
  2. CV axle boot failure

    2015 Dodge Ram Forum
    Anyone else experiencing high failure rate on their CV boots? I have a 2015 1500 Big Horn 4wd 5.7 with 2.5" front leveling spacer added at shocks. This is 3rd winter that I've had to replace CV axles. 1st two were under power train warranty. Not sure if it's caused from increased angle from...
  3. Broken axle

    2019 Dodge Ram Forum - DT
    First snow/ice storm a few weeks ago my wife got my 19 Ram sideways and hit a curb at around 20 mph. The tire (22 inch rim) snapped off the axle and so far they have had to replace nearly everything on the back end including the axle tube that was bent. After getting a list of everything that...
  4. axle shaft will not slide out

    5.7L V8 Specific Topics
    04 ram 2500 5.7L gas Hemi I am replacing Wheel bearing and U Joint on the passenger side. I have finally gotten the wheel bearing out, took a break knowing the axle should just slide out. It won't slide out. When I did the drivers side, once the wheel bearing was out the axle shaft slide...
  5. Stronger Aftermarket CV axle???

    2011 Dodge Ram Forum
    It is looking like I am going to need to replace my driver side cv axle in the relative near future. I figure I will just replace both at the same time. My question is, does anyone make a stronger version for our front half shafts that would be more suited to off-roading than highway use? I...
  6. Ram 5500 rear end shudder.... Limited slip issue?

    2016 Dodge Ram Forum
    I took deliver of my 5500 the very end of last year. I have noticed consistently (as in even after the hour drive home from the dealer) after a long drive on straight roads, a slight shudder from the rear end when turning. At first I attributed it to the Limited slip clutch discs needing to...
  7. 2.8 Bilsteins Won't Affect Your Warranty!! (CV's, etc)

    LD RAM - General Discussion
    When I installed my Bilsteins, I noticed that the passenger side outer CV boot was leaking, and had flung grease around in my wheel well (26,000 miles). Of course I had already completed the driver's side, so I couldn't just take it to the dealer and act like "I didn't do it!". My buddy told me...
  8. Front Stub Axle Will Not Come Out

    4.7L PowerTech V8 Specific Topics
    2002 1500 4.7 4wd Drivers side CV and Stub axle stripped. I have been beating and banging on this thing for 3 days now. I have used a slide hammer, stub axle did not budge. Removed the diff cover tired to beat it out from the inside, still did not budge. tried to remove the Spider Pin but...
  9. Intermittent Harmonic Vibration/Growl Fix

    5.9L V8 Specific Topics
    Firstly, as will become apparent, this applies to 4x4 models only. My truck is a 2nd Gen (1994-2001). I'm not sure about the configuration of the other generations, so this may or may not apply. The Symptoms So, about a year ago, I was chasing an awful noise/vibration for months before I...
  10. Need a new axle shaft. which one?

    Drive Line
    My passenger side front axle shaft is bent and i need another one. I Have looked on Amazon for one but I think im looking at the wrong ones. any help would be greatly appreciated. I found this on Rockauto but im confused because this one says its for the front right but its only 1/2 inch...
  11. Axle help!!!

    Custom Chassis - Drive Line, Suspension - Lifting
    I recently upgraded my 1997 ram 1500. it now has 4.56 gears and lockers built trans and a 360. I broke both my front axle shafts I have access to the dorman shafts for a reasonable offer. my question is... does anyone sell upgraded axle shafts for these? chromoly and such and also are these...
  12. Differential Drop Brackets

    Looking for anyone who has done this or knows where something like this would be available.. Saw an article for a Fabtech lift for the 02-05 1500's, and was intrigued with the differential drop brackets that they have included in this kit. I understand that other crossmembers would have to be...
  13. Axle Shaft, front differential

    Hi, Im going to sort of skip the intro as a newcomer because i need immediate help. I have a 97 dodge Ram 1500 5.2L V8 4x4 and i recently broke my inner and outer axle while four wheelin'. I have the part to replace it but my main question is is there supposed to be a bearing that is supposed to...
  14. loweing an '02 QC

    Custom Chassis - Drive Line, Suspension - Lowering
    I was wondering if I could swap the rear axle to the top of the leaf springs to level my truck out. It is an 2002 QC.
  15. Differential swap 3.55 to 3.92

    5.9L V8 Specific Topics
    Hey guys i'm new to Ram Forumz and these is my first post, I'm having some problems with my 02 Dodge Ram the rear differential just went out on me i called all salvage yards in the area and can't find one with the same gear ratio and my mechanic said he found one but it's going to cost me $1600...
  16. Ball Joint Replacement

    Hi everyone! Obviously, I'm new here. I've had good luck with my Ram (did I say that out loud????) but now it's getting older and more miles (152,000) things are starting to wear. I just had new rubber put on (Michelin LTX) and was going to get an alignment but the shop said my driver side ball...
  17. 3.55 Axle Ratio vs. 3.92 Axle Ratio

    Performance Mods - Engine - 4.7 Liter V8
    Has anyone test drove to compare the 3.55 vs. 3.92 ? I just picked mine up yesterday and I have the 3.55 (It's kinda tough to find one with the 3.92). Anyway, I love the truck and couldn't be happier so far but, I guess I was just wondering. BTW, I decided to put the Q. here rather than in...