Search Results for ‘bed lights’

Hello yall Curious question. I tried wiring up some bed lights in my 2017 Laramie ed. Ram but to no avail. I’ve seen it done on you tube but I can’t get it to work. I tried tapping into the “brown/white” wire on the driver side door panel wiring harness with alligator clips. I am trying to run...

I had an ARE cap installed om my 2020 Laramie a few weeks ago, but cheaped out on any accessories, including lights. Adding some Amazon LED lights now: Demo is using a MC battery, need to figure out how to tap into 12V source at the 7-pin. Any ideas/photos? The dog was no help.

I have a 2020 1500 Laramie with crew cab and short (5' 7") bed. I bought some aftermarket LED lights to mount under the lip of the bed rails, and am wondering what the best way would be to draw power for them. The lighting has its own on/off switch, and I want them to be able to be turned on at...

I just got a truck that has a bed liner, however just found out the bed has factory installed bed lights on all four corners. I'm thinking if I only cut out the bed liner, the lights are still too far back to do any good. Maybe remove them from the bed and try to install on the liner?

I was poking around under my 2010 Laramie and found a white wire with a gray stripe and a purple stripe. It looks factory. Comes out of the harness just above the spare tire on the drivers side. Inboard of the frame rail. Anybdy know what it is for? It is taped off. I'm down there running wires...

So I put on a Lund Tonneau Cover about a month ago and I found it near impossible to see under it at night, and even during a bright sunny day I couldn't see up front by the cab. So I looked around online and saw a bunch of light kits but decided to head to Pep Boys and just make my own kit. I...

Hi folks. New to the forum. My 2016 1500 Laramie did not come with bed lighting. Weird...I thought it was ordered. Anyhow, I searched this forum high and low for 2016 instructions to get it done. I found instructions, but it was done on an older model. I can tell you I followed the...

I have recently installed bed lights, puddle lights and flush mount Rigid aux reverse lights. I started by re-doing a part of my earlier AUX lighting install. Build thread: http://www.ramforumz.com/showthread.php?t=194855 I ended up with 5 different power wires run to either the battery or...