Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Gen 3 Dodge Ram
    I've managed to at least separate my driver-side axle from the knuckle with the help of a 7-ton puller, but the inside is stuck to the intermediate shaft. So far I've tried: prying from multiple angles slide hammer rotating the axle and hammering again spraying the area with wd-40 I've been...
  2. 2013 Dodge Ram Forum
    So a while back driving on the very well maintained and vehicle friendly streets of Norfolk I hit a deep dip pretty hard that basically had see I needed to replace a few things in the front end. I overhauled basically everything in the front end. From struts, Lower and Uppers w/ Control Arms...
  3. 2014 Dodge Ram Forum
    Does anyone know why ram does not sell the passenger side stub shaft for the differential? And why make the drivers side stub shaft serviceable/(able to buy a brand new driver side stub shaft from Mopar) but make full differential rebuild to even access the passenger side stub shaft?
  4. LD RAM - General Discussion
    Replace wheel bearings? The reason I ask is that one of mine has been getting louder recently and I was planning on just doing them after I get back from deployment, but I noticed after my last tire rotation that one of my tires had gotten some mild cupping. So I ordered a couple of SKF bearing...
  5. 5.7L V8 Specific Topics
    I have a 2005 Dodge ram 1500 4x4 5.7 Hemi. I had clunking noise in the front end awhile ago and found it I had a bad CV axle and Front stub drive shaft. Both of them were replaced - no problems after that. A few months down the road I start hearing noises again. Sounds like if you to take your...
1-5 of 5 Results