Search Results for ‘egr’

I have a 2012 Ram 2500 6.7L Cummins that I am looking to do the DPF & EGR deletes on for better fuel mileage. I am hoping to get some input on what everyone thinks is the best package out there for the money. Also I am hoping to be able to install them on my own so if there are any good "how...

I bought my pickup used in 2007 and had always been a Chevy guy until then. I am happy to say that I have never looked back. Times were different then; single, no kids, no pets, just lots of time spent in the woods. The standard cab '94 was perfect for me. Fast forward a few years and now I am...

Just an FYI folks. I started have problems with #7 coil pack a few months ago but I thought it was something else making my truck throw a code on and off. This was due to me changing transmission oil, transfer case oil (not the same!) and the diffs. The new fluid was making it act up for a...

I get 7.0 mpg city, 8.0-8.3 highway!! No matter how i drive( heavy foot on gas pedal or light foot) i am getting almost the same MPG!!!! Ive changed spark plugs! What other things should i check!?? EGR and Oxygen sensor could be the issue?? How can i know if the oxygen sensor needs changing if...

Recently purchased a 2004 Ram 1500 Hemi Magnum with 55K miles. Check engine light came on, ran diagnostic....code reads EGR valve or PCM as the most likely fixes. Any thoughts on what to try first? Any specific ways to tell which of the two it might be? I've read about resetting the PCM but not...

So my truck has been getting pretty bad mpg's, roughly 13-14mpg instead of the 16-17mpg I was getting previously. Took it into my local diesel specialist, and they suggested a new EGR valve and advised that my crankcase breather was also plugged, and needed replacement. I've seen posts and...

2008 Ram 2500 6.7 Diesel, 102,300 miles. Just got back from the Dealership. I had to have one of the O2 sensors replaced again, less than 3,000 miles after it was originally replaced. They recommend that I have a "Wynns EGR Cleaner" done by them, to the tune of $175. I don't find anything...

i have a "car hemi" crate motor that i bought for my durango. knowing i had to change the timing cover,intake and manafolds i thought i was up to the task. while removing the durango motor i could see a few more problems, the truck motor has an EGR valve and a temp sensor that is on the block...

I've got a code kicking PO406 which indicates a EGR problem... Rather than guess... I figured I'd ask first and save myself some time. 2005 Ram W/5.7L Hemi with about 40K on it. Any suggestions?

I was gonna upload pics of the process, but after I saw how simple it was i didn't think there was any need..I got my new one down at napa for just under $50 with the gaskets included. The EGR on the 5.7 is on the passenger front side of the engine, close to the alternator. First of all...