Search Results for ‘ignition’

I have a 2006 ram it was stolen and after I got it back replaced the entire steering wheel and ignition with one from lkq.it came with the transponder key and fob all in one. So the door unlock key and the ignition key are different. Long story short I never put a battery in it.well I messed...

Starts and immediately dies unless I hold key on (which is bad on starter obviously). Code reader says theres not a good connection or key in not in proper position to give any codes. Replaced ECM didnt help. Im stuck. Relay in dash clicks when I attempt to start. Could that be bad...

The truck starts and dies immediately unless I hold the key into the running position (which will screw up starter). I replaced the ECM...did not help. There is a relay in the dash that clicks when I start it. I tried hooking a code reader to it and it wont allow code reader to work because...

So ... my boyfriend borrowed my truck and fell asleep at the wheel running into the median on the highway. I have changed all the control arms and the stabilizer bar and two tires, after doing this I drove it, started and vehicle ran and drove maybe 3 times, very short distances. Upon the 4th...

I have a 2007 ram with 240,000 miles on it and surprisingly it has ran pretty good up to then, a couple days ago i was just casually driving and it shut off on me blinking the ignition light (the one with the two lines and the lightning bolt) I had my reader and read the code and it said...

First I’m gonna start by saying I don’t have oem remote start, I did add an aftermarket one called flashlogic, but I did remove the aftermarket remote start and it still was trying to start randomly. I was doing yard work and I heard the truck cranking trying to start. I figured probably hit the...

So I bought this 99 ram that wouldnt start, the windows didnt work and the blower motor for the a/c didnt work. I played with the ignition and got it to crank up so i knew it was a bad ignition switch along with those other symptoms. I replaced it with a cheap one I got online and it fixed all...

I'm confused. And I've had a hell of a time trying to figure this out. I have a 2006 1500 Sport with a 5.7 Hemi and I can't get it to even offer up anything unless I have someone turning the key while I bang on the a/c compressor. I've paid through the nose already to have my SKIM key...

Ok - need some advice here..... Drove the truck to the store this morning, came home, no issues. 4hrs later heading to lunch - unlock doors with fob, put key in ignition and NOTHING. Like no battery connected. no dashlights, no headlights, no radio....nada. Battery is 30days old, with new...

I have 96 ram 1500. About 10 years ago I put on a remote starter kit from Walmart. It has worked great since install. The truck set while I was over seas so a good 14 months. Now my problem is that when i go to crank the motor via ignition switch everything comes on but the motor does nothing...

Hi I have a ram 2500 deisel 2013 laramie. It only has 54,000 kms on it and Im having some troubles. 1st, a couple times a week when I go to start my truck it makes an awful noise and will not start. The noise sounds similiar to an older key ignition where if you turn the key when it is...

Is there anyway to get factory push button start or something similar installed after vehicle purchase? My 2012 Durango had push button start and you could remove the button and still push in the ignition without the key fob inserted and start the vehicle. With the Ram you have to insert the...

I have a 2012 Ram Diesel, this issue started a few months ago when I noticed I would put the fob in to start the truck turn the fob and it would take a few seconds to actually turn the truck over. Not a huge deal, now I am noticing that now when i start the truck ( it turns over and is running)...

Hello, Hello... This is my first post on The Ram forum.. I'm a senior member over on ChargerFourmz as "Chargeyota" I was a lvl 5 Supporting member but I decided to bump it down so I can support both Ram and the Charger forums. I'm a lvl 1 on both now. :smileup: My first baby, is my beloved 2000...

Hi all. I have a 1998 1500 5.9L. I replaced the spark plugs and wires at the same time I removed what was left of a remote starter that a previous owner had on it(a massive cluster of wires under the steering column). Went to start the truck and it wouldn't start. Went and got a new distributor...

Anyone have an issue with the truck not starting, despite having full power? Yesterday I went to start my truck, but it wouldn't turn over. It was acting like it would if the battery were dead, but the battery was not dead. All other electrical items (stereo, gauges, radar detector, etc.) worked...

1988 D250 318, will not start. It cranks, but no ignition, there is no spark. I have replaced sparkplugs, distributor cap and wires, and solenoid. I purchased an Ignition Control Module, but cannot find the old one for the life of me. Any input would be much appreciated.

1988 D250 318, will not start. It cranks, but no ignition, there is no spark. I have replaced sparkplugs, distributor cap and wires, and solenoid. I purchased an Ignition Control Module, but cannot find the old one for the life of me. Any input would be much appreciated.

1988 D250 318, will not start. It cranks, but no ignition, there is no spark. I have replaced sparkplugs, distributor cap and wires, and solenoid. I purchased an Ignition Control Module, but cannot find the old one for the life of me. Any input would be much appreciated.

Hi Guys, I just installed an Air Lift WirelessOne on board compressor in my truck to run my Air Lift 1000 bags. I mounted the compressor, manifold, and relay above the spare tire bracket in the back (figured that was the best place to keep it as dry as possible without putting it inside the...