DODGE RAM FORUM banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. 4TH Generation Dodge Ram – 2009 to 2018
    2014 ram 1500, sat all winter starting it every couple weeks went to start it before putting it back on the road for the summer and it was dead other than the dome light remote locks and headlight. Bought a battery and put it in and it's still dead. When I put the key in I get the mileage on...
  2. Gen 4 Dodge Ram
    I had my 5.7 decide to shed cylinders 7 and 8 all over the interstate last fall. Finally got a new engine in it a couple weeks ago. I purchased a short block from Fraser engines, not that it's real critical for the issue I'm having. So I got the engine in and everything buttoned up (excluding...
  3. ASK A DODGE RAM TECH!
    2014 Ram 1500 express 5.7 will not crank or start obviously no power inside cab except for the map lights and the ambient LED in upper console. Headlights work but that's about it, took starter relay out used jumper wire and motor turned over but no start even with ignition in run/start. I'm...
  4. 2012 Dodge Ram Forum
    Stopped at stop light truck went dead never crank back. Fuel pump test good, fuel pressure check good. Will turn over but won’t crank. Shows no compression on cylinder 1 and timing off. HELP!!!!! Love my truck and just can’t part with it. Have replaced oil pickup sensor, crank and camshaft...
  5. Powertrain
    ok, I was working on the e fan switch and then I tried to start the truck, one click from the starter and all gears are boxed. I got it to start once after shifting through the gears. Shut it down and never got it running again:(. I really love this truck. With my code reader I get P0403...
  6. ASK A DODGE RAM TECH!
    Start button on dash and remote will not activate starter. All other lights & functions work fine, but starter will not engage by start button on dash or by remote. I suspect that start button switch is bad, but I would have expected remote key fob to still activate starter. Perhaps "Brake"...
  7. Gen 3 Dodge Ram
    No start no crank issue with my 08 ram 1500 hemi. New battery new starter and a new alternator popped fuse number 22 for the ignition feed. Replaced the fuse ran fine shut it off and now it will not start. The fuse is fine any possibility it’s the TIPM? Or something? Any help is appreciated...
  8. HD RAM - GENERAL DISCUSSION
    Anybody ever see code u1197 and u0100? 2012 Dodge Ram 6.7. Manual window, door lock truck. Security light flashes, no start or crank nothing. I’ve cleaned connections, took the tipm apart, checked all fuses, relays, checked ECM connections?? Still no luck thanks.
  9. HD RAM - GENERAL DISCUSSION
    I’ve recently bought a 2012 Dodge Ram 3500 6.7l Diesel 4x4 Reg Cab. Story goes, it was bought at auction, previous owner drove it home. Let the batteries die (with the security alarm set.) Now the truck is a manual door lock truck, I only received 2 keys with the truck, a ignition, and door lock...
  10. 3RD Generation Dodge Ram – 2002 to 2008
    Im at my wits end Ive been building up an 2004 Durango SLT 4.7 for a few years now I thought I was really close to getting it on the road last fall I replaced the solenoid pack in the transmission (also new ball joints new custom dual exhaust front suspension bits etc) I had to stop for...
  11. SUBMIT YOUR QUESTIONS!
    No start, no crank. Live data in TIPM, PCM, TCM and WCM shows the correct key position. Trans range is reading correctly Park/Neutral and all others. New TIPM installed and all modules programmed and up to date, No codes. All modules responsive and communicating. All data wires ohmed to less...
  12. Electrical
    I have a 2005 Ram 1500 with <150K. I personally have only put 1000 miles on it. Picked it up from dealer used as is. A month ago I had the flooded engine issue, pushed the gas down, started right up. Now it seems to be doing the same thing but pushing the gas down doesn't help. When I turn the...
1-12 of 12 Results
Top