DODGE RAM FORUM banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. 5.7L (345 cu in) HEMI V8 Specific Topics
    Hi all, i have searched every forum i can find, tried everything recommended/suggested in all the posts and am having no luck. 2010 Ram 1500 Bighorn 5.7l 136k miles. P0016 is the code that wont go away. Truck starts and runs fine, other than the fact that it wont down shift when heavy on the...
  2. ASK A DODGE RAM TECH!
    A while back my 2014 bighorn 5.7 hemi 4x4 chewed up the cam with a frozen lifter. After shaping new cam and lifters code p0016,p000b will not go away. Changed out cam and crank shaft sensors, vvt solenoid as well. Could this be due to bad timing chain and tensioner? That is the only thing I...
  3. LD RAM - General Discussion
    So all my Ram owners, this motor gurl is lost!! I have a 2011 Ram 1500 4x4 5.7 hemi with 190k on him. I’ve had my head stuck in forums all week trying to figure out the beast. Let’s talk about what started it all. The ole boy started misfiring when going from second to third gear. To my...
  4. 5.7L (345 cu in) HEMI V8 Specific Topics
    2012 Ram 1500 5.7L I was driving to work 3 days ago and I pulled down a driveway and my truck stalled out. I was able to restart it and after when driving I had a loss of power and was unable to use my cruise control and Eco mode did not come on. I has been rough idling and the check engine...
  5. ASK A DODGE RAM TECH!
    At first it was a P0344 and a P0016. So the first thing I did was replace the Cam Sensor (Mopar) and then erased the codes. After two drive cycles the CEL came back with only the P0016 code. I also replaced the Crank sensor and did a relearn. I have inspected the wiring (have not done voltage...
1-5 of 5 Results
Top