Search Results for ‘relay’

I have a 2017 Ram v6 with one radiator fan. It quit working on me and I’m trying to find the relay for it before I replace the whole thing. Anybody have a idea on where the relay is? I’ve looked and looked and it’s nowhere to be found. If you know please be very specific please and thank you

I have a 2020 2500 “Bed Delete”. I have purchased a factory 6’4” bed and installed it. The tailgate is missing the power harness. I have it ordered. Ram/Mopar said this will not be plug and play setup because a bed delete has the tailgate function deleted from the BCM. They advise “I will need...

Starts and immediately dies unless I hold key on (which is bad on starter obviously). Code reader says theres not a good connection or key in not in proper position to give any codes. Replaced ECM didnt help. Im stuck. Relay in dash clicks when I attempt to start. Could that be bad...

I bought a used truck drove it off the lot 500 miles home noticed the fuel gauge stick during a fill up and started reading normal after a quick pit stop. I drove to work the next day no issue sat in for lunch no issue and then when I got off work my truck would crank but would not start. The...

2014 1500 Laramie A few months ago my right front turn signal warning light came on and the flasher would click super fast which normally indicates a light out. The thing is, the lights are working and flashing like normal. Randomly the hyperflash will stop and the turn signals will continue...

I currently own a 2014 ram 1500. Today as I went to activate my left side turn signal, I noticed that my indicator on my dashboard was "hyper flashing" or blinking faster than usual. I tried the same with the right side and it seemed to work fine, no hyper flash. My front left and right turn...

I had a new Delphi fuel pump installed by the dealer Sep 30th and about a month after that my truck wouldn't start. I disconnected the negative side of the battery and then reconnected it after about 45 seconds and it started right up and ran like a best, like usual. 3 weeks later it did it...

I've been an avid Dodge owner for way too many years and have Unfortunately had to learn to do a lot of my own diagnosis and repairs. But this one has me stumped. My 11 Ram is Factory Stock, No mods. I have EVIC controls/cursers and radio controls on my steering wheel. All in one day, my EVIC...

Installed oem 4 button switch panel today with 2 44in light bars, light bars came with wiring harness which includes inline fuse and relay, when wired into oem switch i get power to all 4 buttons but when you connect aux1-4 into remote it just lights up the switch, check voltage and all 4...

I joined this to try to get a question answered. I have troubleshooted issues with my fog lights not working, its not the switch, its not the fuse (there isnt one on 2007). I am told that the relay for the fog lamps may be bad, but I am not able to find the relay location. I was told under the...

Hi guys! I'm trying to install some driving lights that turn on with my high beam via a relay! Normally you just connect a wire to the high beam side of the headlight connector to the relay and when the high beam comes on the relay trips and turns the driving lights on. HOWEVER, that doesn't...

Right trailer brake/turn light will not work. No voltage at the truck connector (7-wire connector). Fuses OK. I have pulled both fuses out and relays stop clicking. One fuse back in at a time and each one starts relay clicking. Trying to trace where this bloody relay is. Sounds like it is...

I was on my into work this morning and I noticed every time I took my foot off the accelerator there was a relay clicking somewhere on the drivers side of the dash the clicking stops when the accelerator is pressed any amount. I tried to match it up to the ECO light coming on but it did not...

As the title says, passenger side lights have all stopped working. I was replacing the license plate light holders on the back bumper and when I disconnected the wire clip, it pulled the male ends out with it and it arced on the metal(I know, I should of disconnected the battery). After a couple...