starter

I have a Dodge Ram 2011 4.7L V8 and I installed a new starter with part number 428000-3050. I started the truck and everything ran fine. Later I looked at the old part and noticed it was 428000-3051. So now I’m a bit worried about what the difference is and if I need to take action on taking...

I have a Dodge Ram 2011 4.7L V8 and I installed a new starter with part number 428000-3050. I started the truck and everything ran fine. Later I looked at the old part and noticed it was 428000-3051. So now I’m a bit worried about what the difference is and if I need to take action on taking...

I had this happen once before after i changed out the 2 fuel filters and after clicking the fuel pump on and off a few times it started but what scared me was all it did was click as if i had a dead battery or bad starter well today it happened again so I popped the hood and checked voltage...

I have a 2005 ram 1500 4wd automatic with the 5.7 Hemi that sometimes will start others the starter will just click. I can get it to start by grounding it out from the battery when it decides not to start. I have replaced all of my ground and hot wires with with 2ga wire, I run a new optima...

I keep blowing my 20amp fuse for my ignition. Starter wires look good. Aaahhhh

Hi I have a ram 2500 deisel 2013 laramie. It only has 54,000 kms on it and Im having some troubles. 1st, a couple times a week when I go to start my truck it makes an awful noise and will not start. The noise sounds similiar to an older key ignition where if you turn the key when it is...

I have a 2012 Ram Diesel, this issue started a few months ago when I noticed I would put the fob in to start the truck turn the fob and it would take a few seconds to actually turn the truck over. Not a huge deal, now I am noticing that now when i start the truck ( it turns over and is running)...

Hi, new to this forum, but long time Dodge truck owner. I am thinking of installing a remote starter switch so I can have the truck cooled by the time I get out to it. I checked the wiring diagrams and see that basically there are three wires I need to work with. One is the Red (R) power wire...

I hope it's okay but this is regarding a Durango. Long story short this problem started when I jumped another car with my Durango and during the process the negative cable popped off the battery and touched the frame of the Durango. It was still running so I parked it in my driveway, but now...

A few months ago my starter went out on my 2001 1500 5.9 and I was able to get it around until I was able to buy a starter, by tapping on the bad starter. Replaced the starter and everything was fine until this morning. The truck is acting as though the starter is bad again. I read out the...

The starter shorted out on my 98 1500, 5.9 2 wd. The main post on the starter arched so bad that it burned completely off. I replaced the starter, no big deal. When I went to boost it with my 09 Ram the voltage at the cables from the 09 went from 14ish to 0 when connected. I suspected that...

Please Help!! lol I have a 2009 Dodge Ram 1500 with a 4.7l engine. It was wrecked in the front had it completely fixed put an 08 4.7 l back in. Worked great for a month now the truck keeps dieing driving down the road. Go to start truck back up starter engages for one second and then stops or...

I have the factory remote start on my 11 ram 1500. Its a bummer that it isn't a 2 way remote start, because i cant tell if my truck starts in the morning. (live in an apartment, don't have a line of sight to the truck.) Is there a way to convert my factory starter to a two way? I saw the drone...

All, I found my truck running by itself on Saturday. The truck does have an autostarter installed. The autostarter was installed 6 months ago and I've never had an issue. I'm not even sure if the autostarter was involved in this case. The truck appeared to be running, but at a much lower...

I have a 03 Ram 1500 4.7, starter engages but engine wont turn over. Replaced the starter and had the same problem. Removed the starter and attempted to 'start' the starter to make sure it would turn and have nothing from the starter. Does the starter ground to the bell housing or is there...