Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 5.7L (345 cu in) HEMI V8 Specific Topics
    Just bought a 2012 5.7 hemi with bad lifters/cam replaced lifters, cam, pushrods, etc. got it all back together and it turns over good and almost starts, but won’t start. Thoughts on where I could have gone wrong? Scanner found issues with o2 sensor, catalyst monitor, O2 sensor heater monitor...
  2. Electrical
    I'm looking at adding a lighter lithium battery to make up for the heavier parts that I'm adding. Does anyone forsee any problems with the sensor package in the truck? Any input on a small battery tray?
  3. 3.9L V6 Specifc Topics
    Hi all! First time poster here. Trying to get a second opinion on my older 2nd gen Ram. My truck has had intermittent stalling/starting problems since the first week of December. The problem only seems to present itself after driving for awhile and then when I come to a stop or slow down and...
  4. Suspension
    Hello all, I've been working on one of my Rams. This one is the '96 1500 4x4 with 318 and A/T. I'd not been able to start this truck for years and thought it was the fuel pump. Well, after dropping the tank and checking, I found out that the pump worked fine. Yes, a lot of work to find out...
  5. Electrical
    1988 D250 318, will not start. It cranks, but no ignition, there is no spark. I have replaced sparkplugs, distributor cap and wires, and solenoid. I purchased an Ignition Control Module, but cannot find the old one for the life of me. Any input would be much appreciated.
  6. 5.2L V8 Specific Topics
    When I try to start my truck it takes anywhere between 10-30 seconds for it to actually start. Then, if I'm not careful, it stalls out and I have to start it again. I then can use it all day and it starts and runs fine. It's only after I let it sit for 8-10 hours that it has problems starting...
  7. 4.7L PowerTech V8 Specific Topics
    Here's the Story... I have had the 2002 1500 w/ 4.7 for 6 months.. has 130K on the truck. Have been dealing with a misfire code on Cylinder #4.. replaced the plugs, swapped the coils around etc... reset the computer and all works fine ... for a while. Then the code comes back. Since it was...
  8. Custom Modifications- Audio & Video
    I have heard it is not wise to add a remote starter to my 5.9 cummins because of the heat plug. Been told that starting it without waiting for the computer to cycle through everything can cause damage to the heat plug and a remote starter doesn't allow the delay to cycle through the start mode...
1-8 of 8 Results