DODGE RAM FORUM banner

wiring

  1. Powertrain
    ok so i have a bit of a problem right now. I'm finishing up my manual swap on my 96 5.2 ram with the nv3500. I've got it almost completely done now, but at the moment I'm getting a crank but no start with no spark to the coil or the distributor cap. Now for starters I went through every forum I...
  2. 2ND Generation Dodge Ram – 1994 to 2001
    I recently bought a 99 ram 1500, 5.9L, 2wd, quad cab. Its definitely a fixer, got it for $900. Ordered a few parts to start fixing it up and make it drivable. I have found a couple cables just hanging loose not connected to anything and I'm sure they are needed somewhere. I'm just seeing if...
  3. Electrical
    Hello, Hoping someone has seem this issue before and can guide me in the right direction. I have a 2005 Ram 1500 and recently all at once had my turn signals, one brake light, and head light stopped working. All turn signals stopped working except the rear passenger side which flashes...
  4. 2015 Dodge Ram Forum
    Quick question about changing out the front seats. I bought a 2015 Ram 1500 with the very, very, very basic front seats (they move forward and back, and recline), and they are killing my back. So, I am looking to swap them out for Ram 1500 seats with the lumbar support, motorized controls...
  5. Electrical
    I have been trying to find answers for a week, now. I can't seem to find exactly what I am looking for, however. I have a 2001 5.2L Ext. Cab. The radiator shroud was missing when I got the truck. Needless to say, my truck does not stay cool very well. I have been wanting to convert over to a...
  6. Electrical
    Hi i just got a 96 ram 1500 and the horn wasn't working at all I replaced the horn and connections but only hear the relay switch when pressing the horn. Why would this be happening or would it just need a new relay switch? I checked the fuses and they are all fine as well. Sorry if this seems...
  7. Electrical
    I was poking around under my 2010 Laramie and found a white wire with a gray stripe and a purple stripe. It looks factory. Comes out of the harness just above the spare tire on the drivers side. Inboard of the frame rail. Anybdy know what it is for? It is taped off. I'm down there running wires...
  8. Electrical
    Can anyone provide any insight on connecting a LED pod light to pre-existing fog light wires? Super difficult? I have 2 amber pods that I would like to wire into the fog lights so that they come on with the fog lights and I don't have to put any switches on the dash. Thanks.
  9. Custom Modifications- Interior & Exterior Lighting
    So I just had my 5 pin switches arrive to hook up my lighting, but I have some questions as to where to find certain wires on the truck. I have attached the pin diagram for reference. I understand the theory of where each pin is meant to connect to, however I just don't know where to find the...
  10. Custom Modifications- Interior & Exterior Lighting
    So I put on a Lund Tonneau Cover about a month ago and I found it near impossible to see under it at night, and even during a bright sunny day I couldn't see up front by the cab. So I looked around online and saw a bunch of light kits but decided to head to Pep Boys and just make my own kit. I...
  11. 2016 Dodge Ram Forum
    I just bought a 2016 Ram Laramie with a power sliding rear window - and I realized that it does not have a rear defroster. My dealer says that they cannot install......I wonder how they would repair / replace if one got damaged?! I would gladly buy a new rear window setup just to have the...
  12. Electrical
    I recently purchased a new set of mirrors. The mirrors that I am replacing were powered and heated. I figured that I never use the heat so I would save some money and get just powered. Turns out the mirrors that are only powered have a different connector than the ones with heat. Is there an...
  13. 2014 Dodge Ram Forum
    Hello everybody. So a couple of months ago my TPMS lights started blinking and dinging in the dash sporadically. The problem went away but then came back last weekend. Then all of a sudden I started getting error codes to "service transmission, continue in drive", "service shifter", "service...
  14. Electrical
    When I bought my Ram, the left hand blinker and my horn would cause my wipers to come on, this has been going on for 2 years and I had not been able to figure out why, even though I tried replacing the stalk. Fast forward to a few days ago, my truck started stalling immediately when I would use...
  15. Custom Modifications- Interior & Exterior Lighting
    Alright, sometime next week I'm installing my off-road HIDs. I've got 2 Floods, and 3 spots that I'm going to wire independently. I'd like a little direction for the guys that have done it. I'd like to use a panel that fits in the blank space under my air conditioning controls. Any thoughts...
  16. Custom Modifications- Audio & Video
    'Evening folks, Today I've started messing around with the installation of the new Android head unit I bought recently. It's a simple and inexpensive unit but, from the looks and feel of it in the first test, it seems great. I am finding myself lost in regards with one of the OEM connectors. I...
  17. Custom Modifications- Audio & Video
    I know there are two different sites people refer to for wiring, one is this thing https://techauthorityonlinedemo.extra.chrysler.com/service/repair/wiring/view/classic.htm which never works, all I get is "The application has encountered an error. For assistance, please call the Help Desk...
  18. Custom Modifications- Audio & Video
    Surely I'm not the only one. Remove tailgate , load camper > no camera. I bought another OEM camera with P68189124AB harness to find I need another cable to make ends meet. I tried a cable from another custom bed install (68253895AA) and it was correct at both ends. does 68200274AA (10ft)...
  19. Custom Modifications- Audio & Video
    So I recently bought a 2013 2500 SLT and am trying to install an aftermarket stereo. Really hoping someone on here can provide some assistance as I am lost. The truck came with the basic uconnect 3.0 radio and really doesn't have any upgrades or additional packages. The problem I am having is...
  20. Custom Modifications- Interior & Exterior Lighting
    My truck came stock with a industrial bumper and I replaced it with the sports package bumper, leaving holes for fog lights. Having no wiring harness, where do I start to look for correct wiring in order to install some fog lights? (Would also like fog lights recommendations, if you have any)...
Top