DODGE RAM FORUM banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hey all,

I have a strange brake issue with a 2500 heavy-duty that I can't figure out. I've read through multiple posts here but haven't found anything to help with what I've got.

So I have the front drivers brake caliper dragging. It starts out small but the more it drives the worse it gets, from the heat build up I would guess. So far here is what has been replaced or done...

Pads, caliper, rotor, both sections of rubber hose, complete fluid flush and change.

Still having the drag issue, what would be next on the list to check?

Thanks,
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #3 ·
Pins slide freely, caliper came with a new mount.

Bleeder is at the top of the caliper, did the standard bleed with a helper pushing the pedal, also did a vacuum bleed after that.

Not sure what you mean by running the scan tool during the bleed
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
Thanks for the info, took a bit but I found a shop that had a scanner capable of doing this.

Followed the procedure but the problem still persists
 
1 - 3 of 3 Posts
Top